In the past years I had many different sites. In 2013 I am finally gathered some of my stuff together on this WordPress site.
7 years later there aren’t any updates. I ignored it and moved around in real life instead. You can find some my old projects though. Hopefully my 2021 will be more generous with this site.
As Lukas Camenzind points it out (http://www.looke.ch/wp/monitoring-esx-servers-with-zabbix), you can monitor ESXi hosts with Zabbix. It is not that easy though, but here is a little guide that can help you along the way. This is a mix of Lukas’ findings, some official VMware documentation and my experience.
Do not forget to read the official Zabbix documentation on installing the agent!
Continue reading “Monitoring VMware ESXi hosts with Zabbix”
We received our new VM host today, so the first thing I wanted to try was live migration. I started with the virsh migrate –help command, then looked up the official documentation to find out what should I exactly do.
What command to run?
As of today, the official libvirt: Guest migration page is a bit outdated and has a lot of different transport modes and configuration available. To be honest, I do not understand the libvirt migration models, and I did not spend much time trying to understand it.
I want to migrate a VM without any interruption and without using any shared storage. So basically the new host will receive a running virtual machine that it never heard about, neither does it have the associated virtual disks. Apart from this, I want the persistent VM to remain persistent on the receiving host.
Continue reading “Live migrating a virtual machine with libvirt without a shared storage”
It is possible to add a disk to your virtual machine, and get it working without restarting the guest. You just have to rescan the PCI bus, to detect the new controller, with:
echo 1 > /sys/bus/pci/rescan
After the above command, the new controller should be visible and the guest should see the new disk(s). PCI hotplug is also available, but you have to load some kernel modules to make it work.
I did not test it, but it should work if you load acpiphp and pci_hotplug (according to Daniel’s post).
Resizing online is possible and it is even better with the new 3.3 Linux kernel
You can extend an
ext4 file system – even if it is your current root and your OS is running. On the other hand, online shrinking is only supported from version 3.3 of the Linux kernel.
In this example, I will show you how I extended a real life, live ~5 GB virtual disk (with an
ext4 file system) to 10 GB.
Read more about the new 3.3 and 3.4 Linux kernel versions at http://www.ibm.com/developerworks/library/l-33linuxkernel/ (thanks Joro).
Continue reading “Online resizing an ext4 root file system”